Metrohm IC Net 2.0 Manuel d'utilisateur télécharger pdf (Page 53)

5.4 761 Compact IC

IC Net 2.0

Second column Program instruction (see below).

In addition to these predefined instructions,

user-defined remote commands can be

entered if activated on the Remote configura-

tion tab.

Third column Parameter for program instruction (see

below).

ENABLED Enable program start (a disabled program

is not started).

<Add> Add new program instruction.

<Delete> Delete selected program instruction.

<Verify> Test the time program (error messages are

displayed if program is wrong).

List of program instructions

The following program instructions can be added to the time pro-

gram on the Program subpage:

Instruction Parameter entry Meaning

Valve Inject, Fill Switch injection valve to "INJECT"

or "FILL" position.

FullScale 50, 250, 1000

µµS/cm

Set full scale range to the se-

lected value.

ICPump on, off Switch on or off the high-pressure

pump.

Flow 0.2 ... 2.5 mL/min Set flow rate of the high-pressure

pump to the desired value.

Pmax 0.0 ... 25.0 MPa Set maximum pressure limit for

the high-pressure pump to the de-

sired value.

Pmin 0.0 ... 25.0 MPa Set minimum pressure limit for

the high-pressure pump to the de-

sired value.

Remote 0, 1, *, p Set remote output lines 1...8 to

the desired values. For entry of the

first value, enter 1, 0, p or *. For en-

try of the other values, move the

cursor in front of the value to be

changed and enter 1, 0, p or *.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 195 196

Pas de commentaire

Metrohm IC Net 2.0 Manuel d'utilisateur Page 53