Metrohm 758 KFD Titrino Manuel d'utilisateur télécharger pdf (Page 122)

3.2 Remote control commands

758 KFD Titrino

118

Recalculation of the measuring data is triggered with $G.

.Write: With "ON", the following nodes can be overwritten:

&Info.DetermData.MP.List, &Info.TitrResults.Var.C4X (X = 0...5),

&Info.TitrResults.TempVar.C7X (X = 0...9), and &Mode.Name.

.ExV: Volume of the exchange unit, with which the determination was

executed

.MPList.1.Attribute: Attribute

.MPList.X: X coordinate, time

.MPList.Y: Y coordinate, volume

.MPList.Z1: Z1 coordinate, measuring value

.MPList.Z2: Z2 coordinate, temperature

3.2.2.106. Info.TitrResults.RS.1.Value read only

etc., up to .9

Info.TitrResults.EP.1.V read only

Info.TitrResults.EP.1.Meas read only

etc., up to .2

Info.TitrResults.Var.C40 read only/read+write

etc., up to .C47

Info.TitrResults.Var.DTime read only/read+write

Info.TitrResults.TempVar.C70 read only/read+write

etc. up to .C79

.RS: Values of the calculated results.

.EP: Endpoints with SET, KFT:

Volume coordinate in mL, e.g. "1.2340"

Measured value coordinate in pH "5.12", mV (with U and Ipol)

"–241" or µA (with Upol) "43.7".

.Var: Various variables. You may overwrite the variables C40...C45, see

3.2.2.105.

C40: Initial measured value in pH "5.12", mV (with U and Ipol)

"41", µA (with Upol) "43.7" or °C (with T) "25.0". In MEAS final

measured value.

C41: End volume with SET and KFT in mL, "12.5360".

C42: Time from start of titration to end in s, "62".

C43: Volume drift on start of a SET/KFT titration from the condi-

tioning in µL/min, "3.5".

C44: (Last measured) temperature in °C. Used for the temperature

compensation in pH measurements.

C45: Start volume with SET and KFT in mL, "2.800".

C46: Asymmetry pH of CAL, "6.89".

C47: Relative electrode slope of CAL, "0.9950".

C48: Voltage at maximum voltage (not valid in CAL and TIP)

C49: Voltage at minimum voltage (not valid in CAL and TIP)

DTime: Time for the drift correction in SET/KFT with conditioning.

.TempVar: Temporary variables in TIP corresponding to the assignments in

the submethods.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 209 210

Commentaires sur ces manuels

Pas de commentaire

Metrohm 758 KFD Titrino Manuel d'utilisateur Page 122

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Metrohm 758 KFD Titrino