Metrohm 860 KF Thermoprep Manuel d'utilisateur télécharger pdf (Page 22)

3.6 Mounting the heating tubing

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭

￭￭￭￭￭￭￭￭

860 KF Thermoprep

Screw the 6.2816.080 outlet needle onto the Luer connector of

the needle holder.

Carefully guide the 6.2816.070 injection needle into the opening

of the distributor from above and allow it to drop down.

Note

Take care to ensure that the white PTFE seal is positioned securely

on the needle.

Screw the 6.1805.100 FEP tubing by hand onto the opening of

the distributor. Screw the other end of the tubing into the opening

on the upper side of the guidance rod.

3.6 Mounting the heating tubing

6.1830.030

6.2060.010

Figure 11 Mounting the heating tubing (view from rear)

Proceed as follows:

Screw the M6 connector of the 6.1830.030 heating tubing into

the side opening of the distributor on the guide head.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Pas de commentaire

Metrohm 860 KF Thermoprep Manuel d'utilisateur Page 22